Forced Regen or Reset Aftertreatment Commands Not Appearing in the App
Forced Regen or Reset Aftertreatment Commands Not Appearing in the App
If certain commands are not appearing in-app, please follow the troubleshooting steps below:
If you use an OTR Link 2
OTR Link 2 is the adapter that comes with OTR Diagnostics plans today. Check these points first, then follow the steps below. The adapter step is for the legacy BLmini only.
- The commands you get depend on your engine. Check your engine on our Vehicle compatibility page or the Engines page.
- Keep the OTR Diagnostics app up to date. OTR Link 2 firmware updates are sent through the app over the Bluetooth connection.
- Detroit Diesel DD13 and DD15 engines from model years 2025 and 2026 need an OTR Link 2 with firmware version 2.0.1 or newer for their commands. See OTR Link 2 firmware updates.
Check the engine profile
Open More > About in the app and make sure the engine profile and engine component sections do NOT state generic or are blank.
-
If the profile and component sections are NOT blank or generic, force close the app and reconnect.
-
Legacy OTR Link (BLmini) only: ensure you are using the correct adapter(s). See the legacy section below.
-
Ensure you are connecting directly into the diagnostic port and are NOT plugging into an ELD or Y-splitter.
-
Ensure you followed the connection steps to properly pair and connect your tool to your phone and truck.
-
If the issue persists, contact our support team at support@otrperformance.com or by calling 586-799-4375.
If the profile and component sections state generic or are blank, follow the steps below:
-
Force close the OTR Diagnostics app, disconnect the tool from the diagnostic port, and remove your key from the ignition.
-
Wait approximately 2 minutes after cycling the parking brake or opening and closing the door.
-
Reopen the app, reconnect, and the issue should be resolved.
-
If the commands are still not appearing, please get in touch with our support team at support@otrperformance.com or by calling 586-799-4375.
The Parameters card is missing
The PARAMETERS card on the Dashboard, and the Parameters card on the Commands tab, appear only when all of these are true:
- You're connected to the truck and your OTR Diagnostics plan is active.
- OTR Diagnostics 4.3.0 or newer is installed on your iPhone. Android is coming soon.
- The engine is a supported Detroit Diesel, Cummins, Volvo or Mack engine. Cummins engines from 2025 on, and Paccar MX and International engines, don't have Parameters yet.
- The engine profile isn't Generic. Follow the steps above to fix a Generic profile.
If the Parameters screen opens but says "No adjustable parameters", the app can't change settings on this engine. See How to change road speed and cruise speed.
Legacy adapter: OTR Link (BLmini)
If you use the legacy OTR Link (BLmini), make sure you are using the correct adapter:
- For 2014+ Volvo/Mack engines, use the Volvo/Mack adapter.
- For 2016-2021 Paccar MX engines, DO NOT use the Paccar adapter.
For the full BLmini steps, see Troubleshooting Connection Issues - OTR Link 2 and BLmini.
Still need help? Contact us

